AWR1243: Programming the DFE

Part Number: AWR1243

Hi,

1) Can the awr1243 DFE be programmed independently of the ADC sampling rate settings or it's parameters automatically set by the chip soft/TI embedded code?

2) If DFE settings are not automatically tied up to the ADC rate and the ADC rate is in the low MHz range would it make sense to sample at the the maximum rate to avoid noise aliasing and than filter the above portion of the spectrum with the DFE?

3) Is  the Programmer's Guide SWRA555–May 2017 AWR1xxx Data Path an appropriate source to use for the baseband programming the awr1243 chip ?

Thank you,

Vladimir Kolinko.