Part Number:TMS320C6746
Hi team,
Right now, I'm working with TMS320C6746 and the TMDSLCDK6748 board. I installed CCS and StarterWare and am trying to work with the mcasp example as a starting point, so I created a new project based on it. I set up the project to use the StarterWare include directories, and for the libraries, I just copied drivers.lib and system_config.lib into the project directory and included them via the linker options.The trouble is I’m not finding a few symbols:
undefined first referenced
symbol in file
--------- ----------------
EDMAVersionGet ../drivers_debug.lib<edma.obj>
I2CPinMuxSetup ./mcaspPlayBk.obj
McASPPinMuxSetup ./mcaspPlayBk.obj
Do you know how I can resolve these dependencies?
Also, when I get something that does compile and link, then try to run it, I get:
C674X_0: Trouble Writing Memory Block at 0x80000000 on Page 0 of Length 0x6c80: This operation is not supported by this driver
C674X_0: File Loader: Verification failed: Target failed to write 0x80000000
C674X_0: GEL: File: C:\tmp\ti\workspace_v9\thumper_test\Debug\thumper_test.out: Load failed.
I’m using the UART cable that came with the kit, and an unmodified C6748.cmd. Any ideas?
Thanks,
Brian