Part Number:DLP4500
Hello everyone, some questions I want to ask.
Sorry, my English is not good, I can only translate from the Internet, please forgive me.
The operational steps are in accordance with the official manual dlpu019a.pdf
First question: Calibration board size of the square problem.
- On page 32 of dlpu019a.pdf "For example, if each square is 2 cm wide, enter "2" into the prompt"
Since the size of the square of the example is "2 cm", you can enter "2" in the command window.
However, I measure my square size is "0.9 cm", so I don't know if I can type "0.9" directly into the command window. Thank you.
Second question: Because of the red line in the picture , If I want the point cloud distance unit to be changed, where should I go to change the size
For example: cm changed to mm, where can I go to set it?
