Hi,

I am using the MSP430FG4618/F2013 Experimenter Board.  I downloaded slac129c (http://www.ti.com/tool/MSP-EXP430FG4618) and compiled some of the programs.  I was able to load several of these programs onto my board.  Now, however, I get the following error message whenever I try uploading:

MSP430: Error connecting to the target: Unknown device

I didn't change anything about my setup in between runs.  It worked one minute, and didn't the next.

I have looked up similar problems, but it seems like everyone else has had this problem at start up.  Has anyone had any experience getting this message after already programming it correctly?

Thanks,

Alex