Part Number:ADS1262
Hello,
I'm trying to read some data, but I don't get anything.
First, I'm able to read and write the registers.
I'm using the ADS1262 on Bipolar mode (+2.5/-2.5), and at 2400SPS PGA:1.
But I don't get any data, even using the continuous mode or pulse mode with start pin or command.
When I send a read data command, I get the status 0x21, so no new data on ADC1 (bit 6), and then DOUT stay low.
The /DRDY stay high all the time, so I suppose that there is no conversion made and I don't get why.
What can be the cause ?
Thank You,
V.Kerbaul