TAS5756M: TAS5756 demo board + mother board set, can work normally, can control debugging (I2C slave address 0x9B/0x9A) ,But it can't be debugged on-line in actual products, PPC2 can't

Mono's Circuit Design           
TAS5756 demo board + mother board set, can work normally, can control debugging (I2C slave address 0x9B/0x9A)

But it can't be debugged on-line in actual products, PPC2 can't

Excuse me, how can we debug online in actual products? control TAS5756.

Actual product: A set of DSP + 5756 power amplifier board. The default setting of the first edition is that only right channel signals are broadcast and left channel signals are not output (I2C slave address 0x9B/0x9A).

The parameters are adjusted on the mother board + EVM board.

Dump output file is imported into the software of the actual product, only the signal of the right channel is played, but the signal of the left channel is not output.

It should be that the mix function has not been exported correctly. (Question: Which registers control the mix function? How to modify the dump file?

(Please visit the site to view this file)