Part Number:ADS1232
Hello all,
I am having problems interfacing with the TI ads1232
I started with the post here: https://e2e.ti.com/support/data-converters/f/73/t/560004?Help-with-setting-up-an-ADS1234-with-4-load-cells-to-an-Arduino-Uno-or-a-Raspberry-Pi-3
I am using a arduino mega to interface with the device.
My circuit is very similar to the one described in the post above, with the exception that my CLKIN is grounded, and i only am using one of the input channels.
I have been trying to troubleshoot the interface by just reading the internal temperature from the device by placing pin 7 high, but I am getting a value of zero.
could you please advise on ways to fix the interface, or verify if the chip is bad?