EVM430-FR6047: Calibration Ranges Issues

Part Number:EVM430-FR6047

Hi!

I tested out your new 02_20_00_15 USS GUI version (EVM430FR6047) and the new Calibration Ranges and I have to concerns:

1. Looking at the waveforms tab, I can only see the offset applied (straight line) by the calibration in the flow rate plot when “Adv. Calibration Table” is enabled.

2. If I disable "Adv. Calibration Table” in the waveform tab, are the calibration table still used or is it only using the meter constant in the plot?

3. As I want to be able to measure negative flows, it seems that I have to duplicate the ranges for the negative flow rates as it does not take the absolute flow value, is the correct workaround?

Thanks in advance!

Best regards,
Thibault