Part Number:AM5706
I'm creating a schematic symbol using Orcad Capture, and in doing so, I have a conflict.
On page 67 of the data sheet, signal vin1a_d16 is connected to ball (pin) M1
Further down the page, signal vin1b_d0 is also connected to ball M1. I'm guessing this is an error.
If this is intentional, It causes a problem, as Orcad won't let you connect 2 different signal names to the same pin.
Some assistance is needed. Is this a misprint? It's not in the published Errata.
Thanks.