Hi Eveyone
I am student and doing a student Project. So for my project I made a two layer PCB Board for CC430F6137. I can program it well using JTAG 2 SPY Interface. For Blinking LED, this PCB board work well. But when I run the code for transmitting some data using inbuilt RF CC1101, it doesn't work. But same code work for eZ430-Chronos Development Kit for 433 MHz.
I also notice one problem with this PCB, when I burn code using JTAG Interface (Blinking Led Using Timer A), It works. But after powering Off and then powering on again, It wont work. So please anyone can suggest me, what can be possible cause for this problem. What can I do next for getting my PCB working. I will be very thankful to them. I need it to working for completing my project. Please suggest me some idea.
Thanks and Regard
Vivek Kumar