i have recently bought a TMDSSOLARPEXPKIT kit with F28035 control card. i just connected it with pc and 20V power supply, initially i saw LEDs in the control card F28035 glowing then in next few seconds it turned off then i noticed that IC in control card is getting heated up so i turned off the supply.
i read the solar explorer hardware guide before giving supply to the kit, i never changed any jumper position.
can u provide me steps how to start this kit with all jumper and switch position to be set for safe operation? and also can u provide me information on how to connect a PV to this board (because i never saw any image of this board connected with panel in its guide) i can understand where to connect PV but still i want to make sure, because i dont want to take risk..
regards
yogesh