Part Number:MSP430G2553
Hello,
I am working with the MSP430G2553 and right now the MSP is on the Launchpad. I am using Hardware UART to connect the MSP to another device. Right now that is working just fine (I switched the jumpers on the Launchpad to enable Hardware UART).
However, in a later stage of the project I want to remove the Launchpad and put the MSP directly into my circuit.
My question: I still want to use Hardware UART when I remove the Lauchpad, is this possible just with the MSP or do I need Launchpad for Hardware UART?
I have already gone through the User's Guide of both MSP and Lauchpad, but could only find very little information about this.
Thank you for your help!
Markus