Part Number:MMWAVE-STUDIO
Hello there,
I'm trying to capture Raw Data from the IWR1443BOOST (ES2.0) using mmWave DevPack and TSW1400EVM. Further used sofware HSDCpro (v4.9), mmWaveStudio (v1.0.0.0) and mmWave DFP v0.7.0.4;
I followed the instructions of this Training: https://training.ti.com/mmwave-sensor-raw-data-capture-using-tsw1400-board?cu=1128486
I could follow this guideline until loading the BBS/MMS firmwares; while the BBS firmware could be loaded, but woudn't be displayed in the correct way at the RadarAPI GUI. Further the MSS doesn't load anyway:
We tried with both jumper settings SOP 100 and 101. But both don't work.
---------------------
In the previous steps various warnings came up, which probably did not lead to serious problems. However, these may be relevant for troubleshooting.
On the one hand the following warning came up in the mmWave Studio Output:
But the script completed successfully.
On the other hand, the HSDCpro immediately after uploading the firmware (AR12xx_lvds_4Channel_ddr_4bit_par_centre_16_bit.ini) showed an error message that no firmware was available:
But in the later step (mmWave Studio RadarAPI: SetUp TSW1400) there was no problem recognizing the board and the trigger was armed. But no Interface type and correct firmare version was displayed:
Thank you very much for your effort.
Best regards
Marc