Hi folks,
I have an ARM3359 (based on ICE), and after I created my Target Configuration, added GEL, etc., I press test connection on my Win7 machine, and CCS v6.0.1 just hangs at this prompt:
[Start: Texas Instruments XDS100v2 USB Emulator_0]
And when I try to debug, then CCS v6.0.1 crashes and shuts down.
I did the following troubleshooting exercises:
1) Checked device manager: I can see the channel A and channel B drivers of the XDS100v2 installed
2) Created a new workspace: Did not work
3) Updated my version of CCS (through the "help" tab): Did not work
4) Uninstalled, restarted computer, downloaded and installed CCS v6.0.1 again, restarted computer: Did not work
5) Created new Target Configuration file and added the GEL file: Did not work
6) Tried communicating with my device through a GUI I created to interface with it: Worked!
7) Tried on another person's Win7 machine with same CCS v6.0.1 (with different Target Configuration and the same GEL file): Worked!
I'm not sure what else to do to make it work on my Win7 worstation laptop