I am trying to connect to a ADS1672EVM attached to a MMB0 Rev D board. I have set all the jumpers according to the manual.
When I first connect the board with USB I get an error that the Device Driver can not be found.
When I try with ADCPro and select the ADS1672EVM module I get a download failed error and the error messages pop up:
When I look at the MMB0 board there appears to be solder shorts on some of the pins. I am not sure if these are common pins that are tracked between pads or if this is the cause pf the problem. Before sending the eval kit back I wanted to know if there is an alternative solution.
Craig Hillis