Part Number:TMS320F28069M
i,
I have custom TMS32F28069M board (TAPAS by Siemens SDI) on which I'm developing an EIS battery measurement system.
I want to use the Matlab/Simulink Embedded Coder for the development and i have been able run simple example models successfully (c28xx_adcpwmasynctest_ert).
Unfortunatly already while the configuring the examples to my board i run into not understandable limitations.
According to https://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/ref/sect-hw-imp-pane-c28x-epwm.html
I should be able to select a pin for the available PWM channels 1 to 8 (according to the datasheet) . In Configuration Parameters -> Hardware Implementation -> Target Hardware Resources -> ePWM onlyonly PWM7A, PWM7B and PWM8A are visible, as shown in the picture.
Is there additional configuration necessary? Or this is a limitation in the embedded coder?
It's challenging to learn the C2000 architecture but also very motivating for what is possible.
Best Regards
Jonathan
