I recently received the Educational Boosterpack (BP-EDUC-01, Rev A2).
I have everything working (RGB, Mic, Potentiometer, ADXL Accelerometer, Buzzer, ....) EXCEPT for the LCD (uses a ST7032 controller).
Per the docs, it appears to be a 4-wire SPI interface, and I am using the SPI hardware, but no joy. Scope shows valid SPI output traffic, RS is toggling as required, but the LCD just sits and does nothing. There is no sample code to validate against, so I am kind of stuck at this point.
I've used the same SPI support to talk successfully to other SPI serial LCDs in the past (ala 43oh's serial LCD), so I know the SPI UCB0CLK and UCB0SOMI part of the logic is working. Also added extra delays in, just in case it was a timing thing. Initialization logic is written exactly as documented in ST7032's datasheet.
Has anyone else tried to program this thing, and/or have sample code or tips to share ?