Part Number:BQ28Z610
Hello,
My question is about the cycle count parameter not incrementing. I am running a bq28z610 fuel gauge in 1S mode. I have fully charged a cell, passing through the cycle count percentage (which I have set to 90%), and discharged the cell below 90%. However, the cycle count does not increment. According to the TRM, the cycle count state is defined as follows in 13.6.10:
As previously stated, cycle count percentage has been set to 90%. I have passed through this threshold in both directions (charge/discharge) with no effect on the cycle count. Is there something else the cycle count is dependent upon that the fuel gauge is looking for?