Part Number:CC1000
Dear Forum Team, We are using CC1000 at 868 MHZ for several years now and we already produced a lot of parts. With the parts of our last lot we have problems with sensitivity -81 to -86 dBm instead of -100 dBm. Output power is OK in all parts. We already did a cross change with working parts and the failure goes with the CC1000. Do you already have any other experience with this issue? Do you have any ideas what changes might help?
Activities we already did:
- We measured all parts and found a quote of 50% working
- We ordered further parts and tempered them, even though the series parts were new and handled correctly
- We checked all surrounding parts - everything is fine so far
- We did the cross change mentioned above
Many thanks for your help.
KR Juergen.