Part Number:TDA2
Tool/software: Linux
Hi everyone,
I am using VSDK Linux configuration running on TDA2x SoC and trying to have communication between TDA2x and hard disk drive via SATA interface. However, I have no communication at all. All 4 signals on SATA connectors are on 0 level. During the u-boot execution I noticed messages SCSI: SATA link 0 timeout.
AHCI 0001.0300 32 slots 1 ports 3 Gbps 0x1 impl SATA mode and during kernel execution message SATA link down (SStatus 0 SControl 300). Can someone explain me what these messages mean?
Also, I noticed that result of command parted -l is giving me only partitions on SD card from which system is run, but there is no SATA device.
Should there be some change in configuration of linux kernel so SATA interface is active?
Thanks in advance,
Sasa