Part Number:CC2531
Hi,
I've been trying to use Z-Tool to create a network and have searched a lot on the internet but haven't understood the way to do so. I have also worked very hard to understand Z-Tool Monitor and Test guide.
I have three CC2531 dongles with z-stack burned onto them. I want to create one of these as a coordinator while the other two as end devices. How to change the device type? As you can see, there is "None" written in the screenshot at present.
After that, I wish to send messages between these. Which commands from the z-tool shall I use to send messages? The guide doesn't explain parameters with examples, so it's getting really confusing.
If anyone can guide me through the process, it will be highly appreciated.
Looking forward to your help
Thank you!