Part Number:MSP-FET
Good Morning everybody!
Today I'm here to highlight an annoying issue with MSP-FET Flash Emulation Tool.
What I noticed is this: if in close proximity of my FET there is, for example, a power strip with on/off switch button and someone else is using it (switching on or off) while I'm doing the debug of my code, the program suddenly gets stuck. This is the same behaviour as if you have some relays on the board on wich you are programming: if I'm in debug mode, step by step, and at some point the relay is triggered, the debug gets stuck and I have to:
--> stop the debug mode
--> disconnect the emulator from both the PC and the board
--> re-connect everything and actually re-start with my debug section.
How is it possible that the emulator is so sensitive?
Is there a way to avoid this annoying behaviour?
I really would appreciate any advice and piece of help.
Kind Regards,
Maria Angela